JOIN NOW

Log in

Making a Pair of 1760 Stays

1760's StaysIzabela gives us a simple, yet accurate construction guide for the non-expert that offers maximum fitting opportunities.

Register to read more...
Gravatar
sweetsap  
  For me it is unclear how the shell is mounted to the lining. When finishing one panel and beginning another are the two shell panels sewn together or is each edge of each panel pressed under and tacked down much like finishing bias edge tape?  
 
Gravatar
finnseach  
  Testing - please ignore.

Judith - Web Tech-type person B-)
 
 
Gravatar
hirondelle  
  Jennifer - they are folded and pressed, then stitched onto the lining - yes, very much like finishing the bias edge tape! stitch one panel directly into the lining, without folding over - the adjacent panel with a folded edge will cover the rough edge. i used that technique on the 1650 gown bodice, it is discussed and illustrarted in the article on the Your wardrobe unlocked!  
 
Gravatar
galadriel  
  How long did this take? I'm about to start my first pair of stays and another article on here said to allow 40-60 hours.  
 
Gravatar
hirondelle  
  depends on how fast you can work! 40-60 hgours does seem a reasonable time frsme - i was making mine in between commissions etc ( part of the chanels were stitched in a car on a way to Scotland at some point...), but i would estimate about 50 hours in total. good luck with yours!  
 
Gravatar
ladybrie  
  Hmm. Are the stays supposed to bow out from the bust and hips in the front? I thought stays of this era where supposed to be flat in front and conical.  
 
Hide comment form

1000 Characters left


FacebookTwitterGoogle Bookmarks Pin It

Save

Save

Go to top